EFSM's latest activity
-
EEFSM replied to the thread Stihl Pullin'.It’s all about technique. People who engage Stihl’s plastic pawls before pulling are fine. Those who don’t will wear out the pawls...
-
EEFSM replied to the thread Husqvarna 564xp porting.I agree, but competence is so lacking in today’s world that I’ve become somewhat cynical.
-
EI would think/hope the company supplying the cylinder knows what the are doing. In regards to your comment on Husky strato saws and...
-
EEFSM reacted to Workshop's post in the thread how about a Oklahoma,AR,MO,KS,TX,+IA GTG thread? with
Like.
This evening I officially became a Great Grandfather. -
EEFSM replied to the thread Stihl Pullin'.A lot of it is the poor startup timing curves in the coils. Also super dumb starter design doesn’t help.
-
EEFSM replied to the thread how about a Oklahoma,AR,MO,KS,TX,+IA GTG thread?.Pin type meters are cheap, but they are not considered very consistent. High dollar pinless is the only way to avoid unlimited frustration.
-
EEFSM reacted to Sawdust Man's post in the thread how about a Oklahoma,AR,MO,KS,TX,+IA GTG thread? with Like.
Sawed up the mystery log. Stinks like....oh my! Cedar elm seems the most likely ID on it. Pretty blah looking wood. Cuts about like...
-
EEFSM reacted to Hedgerow's post in the thread how about a Oklahoma,AR,MO,KS,TX,+IA GTG thread? with Like.
This one..
-
EEFSM replied to the thread Husqvarna 564xp porting.It’s hard to tell from these pictures, but I’d say the honing is rougher in this 564 cylinder than average. You’re right in saying that...
-
EYes, because they hold less oil and have more bearing area on the ring. Regardless this is sorting fly shat from pepper. Saws have such...
-
EEFSM replied to the thread The Official Farming Thread....I’m late to the sob story party, but I visited a neighbor recently asking if I could buy some cypress knees from him (part of a tree...
-
EEFSM replied to the thread What's on your bench?.I thought you said you had pressure tested it and it was okay.
-
EEFSM replied to the thread Fool proof saw?.It would be nice if someone would offer a quality big bore kit for them. The crankcase and crankshaft could handle a lot more power, due...
-
EHard to beat a 590 for value for the dollar. Note I did not say it is "the best" saw for any particular thing, but for many folks' needs...
-
EEFSM reacted to Sawdust Man's post in the thread how about a Oklahoma,AR,MO,KS,TX,+IA GTG thread? with Like.
35/72 & sunny..... 🥵 Good morning.