EFSM's latest activity
-
EStill working on these things…. Going for 105 ex 122 uppers 78 intake Hands have been feeling bad lately and I’m concerned I’ll f...
-
EMaybe a bit off topic but the biggest improvement in cutting quality I can get is to have a nice sharp dialed in chain on any saw. Pure...
-
EI’m all for advancements, so don’t get me wrong. Everyone looks at this fuel injection like it’s magic and it’s going to do for...
-
ENot to disparage any individual rather people in general including myself, I find that 9 times out of ten that the last place something...
-
EI bought this to use with my pressure washer. It works well. I have a “survivor” 98 Ram Cummins that I cannot let rust get started as...
-
EMetering gasket and diaphragm orientation inverted, or improper metering lever height would be possible culprits.
-
EEFSM replied to the thread Stihl 020t wont rev up.Did you do anything with the metering lever? Does this carburetor have an accelerator plunger?
-
EGreat find! Nice price and an easy fix makes that a really good deal. Enjoy!
-
EI did not make the squish cutter it is from dyno joe. The rings are interchangeable and can change what size cylinder you want to cut...
-
EHere’s my personal top handle.
-
EEFSM replied to the thread What's on your bench?.That is a unique tool. Are those red rings interchangeable for different bores? Did you make it yourself? Can you only cut for flat...
-
EEFSM replied to the thread So what did you buy today.I bought this for 139 plus free shipping (new our dealer cost is about 270, list price 330). It was being sold because it had a fuel...
-
-
EFuel mix leaked into the crankcase from a leaking needle and seat in the carburetor, it fired up and next revolution went pop.
-
ELike almost all Chinese parts, all they care about is the sale
-
E"not my saw" is what I heard around 20:20 and "I ported it" near the end.
