EFSM's latest activity
-
EEFSM replied to the thread Oil questions....I think Stens is FD rated for what it’s worth.
-
EDo you know why they call them ‘Dad jokes’? . . . . (Because the answer / punchline is ‘a parent’!) Philbert
-
EEFSM replied to the thread SOLD Fully Rebuilt 288xp.Developing x-ray vision. That sounds dangerous.
-
EMy wife can take one look at a box and say, "Another cylinder, eh?"
-
ESailed! Going to South Carolina!
-
EEFSM replied to the thread Oil questions....Just got done rebuilding a 461 that burned up on Ultra, although it was running lean. Ultra just doesn’t give you a margin for error. I...
-
EEFSM replied to the thread Oil questions....What a crock of.
-
EWhy do you think those are ruled out? Why did you expect to get good information from Stihl or a dealer?
-
EEFSM replied to the thread treemonkey stuff.Reducing the gap should technically advance the timing slightly but I don’t know if the smaller spark would be counterproductive.
-
EEFSM replied to the thread Carburetor Float Bowl Gasket for Briggs 817426 Carburetor.I didn’t take offense; I was trying to show that I’m wasn’t taking an uneducated stab on the dark.
-
EWith used junk, anything is possible. I just have never went into a new to me saw assuming something like that. If I got a saw under...
-
ENaw - those look like pretty average wear marks to me. Most two-cycle pistons will pick up wear lines or marks. Apart from the burnt oil...
-
EEFSM reacted to LAWN BOY's post in the thread 2025 Christmas Giveaway Saw MS390 - Boedy @ Empire Builders (Closed) with
Like.
That's the very reason I got a PO box. Understandable. -
ESir, If you have some sort of an issue with me it would be best to pick up the phone and call me direct instead of trying to make jabs...
-
EHello All. Thanks for the answers. You wont believe it, I got the carb off the bench this morning and was going over the answers...
