EFSM's latest activity
-
EEFSM replied to the thread So does anyone fish or just nah???.I haven’t been following this thread. Where are you fishing?
-
EEFSM replied to the thread What's on your bench?.How much less could you get by with for 93? Or some crazy 114 leaded?
-
EOr it means I have to do twice as many burnouts on any given night, lol.
-
EThey are…I’m not sure it provides any real benefit over an as-cast chamber other than the chamber volume is more consistent. In this...
-
EEFSM replied to the thread Grease Monkey Garage.My question, “why would anyone live where it is routinely that cold?” But most of us are secretly jealous. Good to see you’re still...
-
EEFSM replied to the thread What's on your bench?.Are the combustion chambers also machined and if so, what is the benefit?
-
EEFSM replied to the thread What's on your bench?.“Ok, pile in. Half of you can go on a spin tonight and half tomorrow.”
-
EEFSM replied to the thread What's on your bench?.How many of your family will fit in that (car)? What vehicle is it?
-
EHere are some other pics. I just got the shortblock and heads back from the shop. The heads are cnc ported Kauffman D-port for...
-
EEFSM replied to the thread What's on your bench?.When I first held it WOT, it was singing lean and bouncing madly off the rev limiter. That makes it so hard to adjust the carburetor...
-
EI did go a little bit crazy on them. The metal worker in me kept raising the bar, this is as high as I can reach without putting my...
-
EThe 1/4" pitch queens have been doing exceptionally well. Top by @huskihl Kevin Bottom by @Crocky28 Mark Left bone stock Right on the...
-
EEFSM replied to the thread What's on your bench?.I should have added that they look too nice to be clutch tools.
-
EThose are clutch removal tools. :thumbsup: Heavy duty, solid steel milled.
-
EI started just making my own 79xx clutch tool, the prototypes were ugly and the first version skinny. Then I made 3 Husqvarna versions...
