EFSM's latest activity
-
EEFSM reacted to Stump Shot's post in the thread SELLING Stihl MS650 Cylinder and Piston new with
Like.
They are a porters dream, everything lines up nicely with the lathe work, unlike the bigger 660 cylinder which can be all over the place. -
EOld Porsche engines too
-
EEFSM replied to the thread Saw building 101?.I think that is standard practice with Lycoming aircraft engines. Thread and sealant.
-
EEFSM replied to the thread HELP! Ms 290 stihl.Make sure the intake boot and pulse line are fine (maybe that is tested in your vacuum test). Check for carb issues and cracked OR...
-
EEFSM replied to the thread SELLING Stihl MS650 Cylinder and Piston new.Maybe you should give a sales pitch? I understand this is the small bore version of a 660 p&c. Are there any advantages to it other than...
-
EIf IT BITES it ain't done yet...
-
EFlorida Water Test: Dip your finger in the water and taste it: - if it’s salty: crocodiles; - if it’s not salty: alligators. Philbert
-
EEFSM replied to the thread Makita exits gas equipment manufacturing.Who knows? Lockheed had to cut up the tooling for the SR-71 so no other government could get access to it. Maybe Dolmar did the same.
-
EEFSM replied to the thread WANTED Complete-ish Stihl 064 or early short cased 066.If only people would get a real job…
-
EEFSM replied to the thread Battery Chargers.I didn’t know that they used Panasonic under the hood too. I knew they used them as the accessory battery in hybrids.
-
EEFSM replied to the thread Carburetor Float Bowl Gasket for Briggs 817426 Carburetor.? Not sure I understand.
-
EEFSM replied to the thread Battery Chargers.Was this a hybrid 12v battery in the trunk?
-
EEFSM reacted to jacob j.'s post in the thread Stock and Modded “can” mufflers vs pipes - an honest discussion without any attitude with Like.
I locked the thread to clean it up - I'm with you, there was an excellent discussion going on until it got off the rails. I apologize to...
-
EEFSM replied to the thread Carburetor Float Bowl Gasket for Briggs 817426 Carburetor.I’m 99% sure that will interchange with a large Honda GX 390 bowl gasket...
-
EEFSM replied to the thread Any Chinese chainsaw and chinese parts discussion.Are these saws better than Neotec? Last week, I was working on a Neotec NS872 that had absolutely terrible fit and finish.