EFSM's latest activity
-
EFlorida Water Test: Dip your finger in the water and taste it: - if it’s salty: crocodiles; - if it’s not salty: alligators. Philbert
-
EEFSM replied to the thread Makita exits gas equipment manufacturing.Who knows? Lockheed had to cut up the tooling for the SR-71 so no other government could get access to it. Maybe Dolmar did the same.
-
EEFSM replied to the thread WANTED Complete-ish Stihl 064 or early short cased 066.If only people would get a real job…
-
EEFSM replied to the thread Battery Chargers.I didn’t know that they used Panasonic under the hood too. I knew they used them as the accessory battery in hybrids.
-
EEFSM replied to the thread Carburetor Float Bowl Gasket for Briggs 817426 Carburetor.? Not sure I understand.
-
EEFSM replied to the thread Battery Chargers.Was this a hybrid 12v battery in the trunk?
-
EEFSM reacted to jacob j.'s post in the thread Stock and Modded “can” mufflers vs pipes - an honest discussion without any attitude with
Like.
I locked the thread to clean it up - I'm with you, there was an excellent discussion going on until it got off the rails. I apologize to... -
EEFSM replied to the thread Carburetor Float Bowl Gasket for Briggs 817426 Carburetor.I’m 99% sure that will interchange with a large Honda GX 390 bowl gasket...
-
EEFSM replied to the thread Any Chinese chainsaw and chinese parts discussion.Are these saws better than Neotec? Last week, I was working on a Neotec NS872 that had absolutely terrible fit and finish.
-
EHeres some pics of a red oak from the old lumber capitol of pennsylvania aka williamsport. 64"gb some oregon .404 hyperskip 3120 xs 58"...
-
EEFSM reacted to Ketchup's post in the thread Stock and Modded “can” mufflers vs pipes - an honest discussion without any attitude with Like.
I also have some specific questions about expansion chamber pipes: How many degrees of rotation can the pressure wave force charge back...
-
EEFSM replied to the thread SOLD Husqvarna 357xp.That is fascinating the way those auto decomp valves are supposed to work. It’s a little too finicky for a chainsaw though.
-
EEFSM reacted to Ketchup's post in the thread Stock and Modded “can” mufflers vs pipes - an honest discussion without any attitude with Like.
Sure, I’ll bite. So you seem convinced that a dual outlet crack-pipe (sorry, I’ve always called it that because the single outlet ones...
-
EAh, there's backstory I don't know about here! You're not alone. At this point, I hope everybody can put away their dicks of whatever...
-
EEFSM replied to the thread Makita exits gas equipment manufacturing.I think he's talking about Stihl, which is also German. However, I wouldn't be surprised if the government would stand in the way of an...