EFSM's latest activity
-
EEFSM replied to the thread Worn Chrome.Then the shiny area is what is worn and the dull is factory finish.
-
EEFSM replied to the thread Worn Chrome.It would be interesting to know how much wear the piston skirt has. Did you measure it? It can sometimes be hard to tell if you’re...
-
EEFSM replied to the thread HELP! Stihl 076 AV Super- Bogs and Dies When Hot.Have you concluded what the smoke was from? Was the flywheel contacting the coil at all (due to crankshaft movement )? I’d also check...
-
EEFSM reacted to Al Smith's post in the thread HELP! Stihl 076 AV Super- Bogs and Dies When Hot with
Like.
That control valve is what most call a rattle ball governor .Two carbs are listed for that saw OEM and both indicate a rattle ball .It... -
ESometimes we never know....my wife's Grandpa came in from milking cows in the morning and told his wife he did not feel well and needed...
-
EEFSM replied to the thread Honda HRH 537 vs Kaaz pro.Did you end up with one of these?
-
EIt also can be a good way of dialing in timing with a cheap aftermarket piston before cutting on an expensive jug.
-
EYes, I agree that is frustrating, and no dimensions or thread pitch on the screws either ...
-
EEFSM replied to the thread HELP! Understanding piston design.Yes, although it will reduce compression
-
EEFSM replied to the thread Dummy Decomp Valve.I have seen that, although it wasn’t dummy. The air came out around the shaft. I don’t remember if it was on a Stihl or Husqvarna.
-
EMore truth, and probably the biggest reason blades brake too early.
-
EEFSM replied to the thread HELP! Stumped on Stihl TS420 rewind starter.Totally true. Why put it on the dirty side of the engine? Echo seals their starter with oil seals so that no dirt can get in and of...
-
EEFSM replied to the thread What? No bandsaw milling threads?.It also depends on how dull you run the blades. We have a neighbor that sharpens and sets them for 7 or 8 dollars. For that it’s not...