EFSM's latest activity
-
EEFSM replied to the thread Rich coming off of WOT.Try raising the pop-off pressure, maybe a stronger metering spring or setting the lever lower than it should be.
-
EEFSM replied to the thread Echo Saws: Who Are They Marketing To?.There are no HD only models currently. In the past, that was the case with an old battery platform for a couple of years until the...
-
EEFSM replied to the thread Stihl 021 Craps Out On Idle.Are you sure the compression is good? What you're describing sounds like low crankcase compression, due either to bad rings or a worn...
-
EPoulan hasn't made anything since Reagan was in office.
-
EEFSM reacted to fossil's post in the thread Funny pic's and gifs 2021/2022/2023/2024/2025 with
Like.
-
EEFSM replied to the thread buying just 4-stroke carb bowl oring gasket.https://www.stens.com/485-974-float-bowl-gaskets I can't guarantee this is right, but I've never run into a Honda clone style...
-
EEFSM replied to the thread does poulan still make weed trimmers?.Parent company Husqvarna has been shuffling brands in recent years. My interest in whether they are still making Poulan trimmers is so...
-
EEFSM replied to the thread Stihl 021 Craps Out On Idle.I would be concerned about an air leak. Sucking maverick air will make it run like crazy wide open but has a drastic affect on idle...
-
EEFSM replied to the thread Husqvarna 2100 thread.I worked on one recently with a moderately worn thin ring piston and was surprised with how low the compression felt. The thick rings...
-
EEFSM replied to the thread Shindaiwa trimmer head?.https://www.ebay.com/itm/254306482305?_skw=X472000012&epid=12017819135&itmmeta=01K0VQGWA6HHFRWEWG0WJ64J5C&hash=item3b35d8f881:g:TZgAAOSwO...
-
EEFSM replied to the thread Shindaiwa trimmer head?.X472000012 is the right part number. X472000070 is for the newer 400 heads. You received the right part number but the wrong part. The...
-
EEFSM replied to the thread Husky 365 Piston Skirt Rapid Disassembly - Potential Causes?.I would blame a worn piston skirt. The intake side is where the dirt and power stroke pressure are.
-
EEFSM replied to the thread Kohler Pistons From Little Red Barn.For an old cast iron block?
-
EEFSM replied to the thread Zama S63: High screw - anyone know how to remove?.The pin is pressed into the carb body. The white insert is probably a friction plug that presses against the needle.
-
EEFSM replied to the thread What Stihl trimmer should I get?.https://www.ebay.com/itm/325920625410