EFSM's latest activity
-
EEFSM replied to the thread HELP! Parts source for Robin NB211 trimmer?.We used to be a Robin dealer. I’ll look to see if we have anything. I’ll try to get back to you this weekend.
-
EEFSM replied to the thread Echo SRM-2620T.Where is the plastic stuck onto the drive cable? If it is at one of the ends, it could be that the little rubber plug at the end melted...
-
EEFSM replied to the thread ECHO Echo, Echo, Echo.I’d probably set the idle at 2800 RPMs.
-
EEFSM replied to the thread What Stihl trimmer should I get?.Could you elaborate?
-
EEFSM reacted to srcarr52's post in the thread HELP! Help with first time porting Echo 800P with
Like.
Thanks, I use 3/8" diamond ball in a #28 handpiece. https://www.mcmaster.com/4490A49/ -
EEFSM replied to the thread Tachometer.Echo 99051130017/Oppama PET-1000 has been our go to for many years. However,we got them before the price was $150. Archer has a cheaper...
-
EEFSM replied to the thread ECHO Echo, Echo, Echo.Was anything wrapped around outside of the crankshaft? Was the oiler gear stiff on the crank? I don’t know that I’ve ever seen anything...
-
EEFSM replied to the thread 400.1 first impression.My gauge maxes out at 30. Not surprised if they are 40.
-
EEFSM replied to the thread 400.1 first impression.Sounds like a pop of pressure may be too high, a little bit like the Husqvarna 550s and 562. Some of them are over 30 psi from stock.
-
EEFSM replied to the thread HELP! How to know when you have too much hook.There is no substitute for knowing what a properly sharpened chain looks like.
-
EEFSM replied to the thread HELP! Help with first time porting Echo 800P.That port chamfering is a work of art. Having ported quite a few cylinders I know how hard it is to get a consistent bevel like that.
-
EEFSM replied to the thread FH580v ES20 not charging battery.The battery should ideally be charging at least 13.5 volts at WOT. If not, check voltage at the red or purple wire at the regulator...
-
E@EFSM - I simply made some additional adjustments to the L adjustment and it seemed to work O.K. I also showed the owner how to use the...
-
EEFSM replied to the thread HUSQVARNA HUSQVARNA THREAD.Did you ever get this saw sorted out? IIRC those carburetors have an accelerator plunger. When the oring is bad on it weird things happen.
-
EEFSM replied to the thread HELP! How to know when you have too much hook.It all depends on what you’re looking for. The sharper the hook the faster it should cut but it will have a more fragile cutting edge.