edisto's latest activity
-
I think you meant to say annealed it. Heat it up, hold it for a bit, and then let cool very slowly to remove and hardening. -
edisto reacted to Mad Professor's post in the thread Stock and Modded “can” mufflers vs pipes - an honest discussion without any attitude with
Like.
This thread has me doing flashbacks to my dirtbike/motocross days as a teenager already......... -
edisto reacted to huskihl's post in the thread Stock and Modded “can” mufflers vs pipes - an honest discussion without any attitude with Like.
Not the ramp in particular like you mentioned, but I believe in the other thread I commented about bigger holes, easier pathways...
-
edisto reacted to Ketchup's post in the thread Stock and Modded “can” mufflers vs pipes - an honest discussion without any attitude with Like.
Okay, so potentially an expansion chamber could achieve 30ish degrees of supercharge if the blowdown were that long. What effect does...
-
edisto replied to the thread Stock and Modded “can” mufflers vs pipes - an honest discussion without any attitude.The stinger length and diameter are sized to generate pressure in the chamber, which is why a good portion of the length can be inside...
-
edisto reacted to heimannm's post in the thread Stock and Modded “can” mufflers vs pipes - an honest discussion without any attitude with Like.
-
edisto reacted to jacob j.'s post in the thread Stock and Modded “can” mufflers vs pipes - an honest discussion without any attitude with Like.
I locked the thread to clean it up - I'm with you, there was an excellent discussion going on until it got off the rails. I apologize to...
-
edisto replied to the thread Stock and Modded “can” mufflers vs pipes - an honest discussion without any attitude.That is my understanding. Technically, the "stuffing" part (supercharging) doesn't begin untiI the transfers are closed enough to...
-
edisto reacted to Ketchup's post in the thread Stock and Modded “can” mufflers vs pipes - an honest discussion without any attitude with Like.
I also have some specific questions about expansion chamber pipes: How many degrees of rotation can the pressure wave force charge back...
-
edisto replied to the thread Stock and Modded “can” mufflers vs pipes - an honest discussion without any attitude.Good luck with that. To address some of your questions in a general way, the duration of the positive pulse will depend on the...
-
edisto reacted to Ketchup's post in the thread Stock and Modded “can” mufflers vs pipes - an honest discussion without any attitude with Like.
Sure, I’ll bite. So you seem convinced that a dual outlet crack-pipe (sorry, I’ve always called it that because the single outlet ones...
-
edisto replied to the thread treemonkey stuff.Maybe we need separate bolts, screws, and holes threads for each brand to spread out the trolling? On a separate note...where did you...
-
You could make a Damascus stack with the short pieces.
-
I couldn't get the CR-V Allen wrench cutoff threaded so I tried tempering it. It helped, I got a M10x1.5 thread about 30mm deep into...
-
Like I said earlier, it’s not an opinion. I’ve done lots of my own testing and seen the dyno charts from others. But even to someone...