edisto's latest activity
-
Amen. -
Cheap, plentiful and biodegradable...make sure you buy a can for the shop, you don't want to get yelled at when the can in the kitchen...
-
Looking for that EMOJi with a thoughtfully raised eyebrow. Ford 2 liter in the 80's REQUIRED that NEW head bolts be used. (NOTE the...
-
Never said it wasn’t. But you need a longer pipe for maximum performance at targeted lower RPMs than you do for maximum performance at...
-
….. says the guy who’s been trying to make a living selling dog dicks for 5 years… It’s all been tested, it’s all been tried. The tiny...
-
edisto replied to the thread Chainsaw Pipe Exhaust theory.RPM and temperature are directly related. No-one said that there isn't an improvement. Just that the improvement is a matter of...
-
But then you're just trading it for other problems.
-
Pam
-
edisto replied to the thread Snowblowers and teflon spray.I was about to suggest the same thing. Works wonders on a shovel in the red clay they have down here.
-
I’ve seen several stripped case holes. 066, 372, 200t. Probably from someone using too much torque starting the bolt (like if the...
-
edisto replied to the thread treemonkey stuff.No stretch would mean no holding force.
-
edisto replied to the thread treemonkey stuff.
-
Is that a fact? I've built a couple of saws. I've had to extract a few broken cylinder bolts. I've never had a stripped cylinder hole...
-
The 3-pawl type, yes.
-
May not be two or more of any OEM part available at any given time, except maybe a clutch cover and flywheel side air manifold.
