edisto's latest activity
-
At the recommendation of others here, I just got a pack off of Amazon and once I heat treated it, then it stood up to the trigger/choke... -
395XP with @tree monkey large deflector with a Husqvarna screen and Stihl exhaust gasket. All three line up perfectly and work together...
-
They left here Monday.
-
edisto reacted to Sloughfoot's post in the thread HELP! How to know when you have too much hook with
Like.
Yeh, I take the gullet out with a bigger round file occasionally only to get it out of the way. Hitting it unnecessarily when... -
edisto reacted to Squish9's post in the thread HELP! How to know when you have too much hook with Like.
This is the most common thing I see these days. People have heard get the gullet, they dig in deep, miss everything that matters and end...
-
edisto replied to the thread HELP! How to know when you have too much hook.I have had at least 2 people ask me how to file a chain, because they couldn't get it sharp. Once I explained to them that it is the...
-
edisto reacted to Maintenance Chief's post in the thread HELP! How to know when you have too much hook with Like.
Remember that you should have 10-15% of the round file above the top plate. If the file is diving down farther in the cutter your...
-
I use the mesh shield when chainsawing, trimming and on my riding mower. Keeps the grasshoppers from hitting me in the face while...
-
The original starter handle would have been a more conventional T shaped rubber handle. I was able to add this 620 to the collection...
-
I just tig weld in an extension into the OEM rod.
-
I have used bicycle spokes for throttle rods, after bending it, temper it with heat and then oil bath...worked out great for an 075 with...
-
Maybe figure it out with brazing rod then match it up. That stuff bends, unbends, and bends again pretty well, but holds a bend too...
-
I just needed to get the surfaces flat and parallel, milling out the welds is not needed for the intended purpose. 6 insert mill...
-
Some of the trophy's I weld/fab for the Car Show Ive been involved with since 2001. I make the bases and plaques at my work
-
Making a new clamping aid, the steel stock I had was not wide enough so I stick welded two together. I did not expect the stick weld to...