Duce's latest activity
-
I have seen sugi too. But maybe because og availability? I hav run it for half a tank after porting and i think its ok for a 60cc saw... -
Very easy to work on, coil etc sits to the right side of saw next to intake. Looks like Huaqvarna tries to make a better produkt here...
-
Awesome post !
-
Looks like a tsumura bar under the Husqvarna paint.
-
Just seen this on Facebook.
-
Yes, but this kind of saws sometimes can’t be helped.
-
I think what he might be referring to is you will end up working on them a lot, kind of like that one girlfriend....very needy, ends up...
-
All 592s are autotune 3 so I don’t believe there’s a need to have anything synchronized. Always heard the only time you needed to do...
-
Duce replied to the thread What yer cheap saw favorites?.Isn’t that what this forum is about, working on saws?
-
Duce replied to the thread What yer cheap saw favorites?.Agree on Neotec. Purchased 2-845, 6200, 6800. Cut intake gasket on 845’s. That 6800 with 22”bar cuts buried in red oak. Gave one 845 and...
-
When you say “cheap”. I think cheap. Not middle. The Zenoah clones of better quality, especially Neotec 6200. No idea how to post...
-
Really well until the hyfax slides wear out. They need snow/water for lubrication on the bottom of the rails and for radiators under the...
-
I’m not familiar with tuning that saw by rpm but that sounds too high, too lean to me. Does it 4 stroke?
-
I accidently washed mine in cold water. Stihl refuses to acknowledge my warranty claims.
-
40 years ago I was doing serious logging with my wind up Poulan Micro!
