Duane(Pa)'s latest activity
-
Duane(Pa) reacted to Khntr85's post in the thread Chainsaw grinder questions, tips, tricks, and pics!!!! with
Like.
Any of you guys ever get the square jig??? I’ve used mine quite a bit and it’s easy to use and turns out a great chain!!!! -
Duane(Pa) replied to the thread SELLING Sugi Hara Lightweight Bar KO95 3/8"x 18" x .050 x 68dl.No. They are SMH unmolested. Pretty sure I went 3/16 on oil hole.
-
Duane(Pa) replied to the thread SELLING Sugi Hara Lightweight Bar KO95 3/8"x 18" x .050 x 68dl.Make an offer. I'm going .325 on everything under 20"
-
Duane(Pa) replied to the thread T&S CZ223 review.I have never precisely measured my top plate angle. It is considerably less than the 30 degree witness mark. For people wondering how to...
-
Actually, I measured the top plate again and it is right at 23 degrees. I think I will like that angle but need to get it in some wood.
-
It really is. I was able to convert the round ground chains over to square pretty quickly all things considered. Once I got the angles...
-
Duane(Pa) replied to the thread T&S CZ223 review.Congratulations! YOLO If you’re anything like me, there won’t be any round chains left in the arsenal. In the videos, that grinder...
-
This thread tipped me toward the T&S grinder over the Simington. I have been wanting a square grinder for over 30 years but could never...
-
Duane(Pa) posted the thread SELLING Sugi Hara Lightweight Bar KO95 3/8"x 18" x .050 x 68dl in Parts Only.Like new Sugi. Fits small mount husky and others. I drilled the oil hole slightly larger diameter. $80.00 shipped lower 48. I actually...
-
-
Not really. But like many other stuff, a break in period. I have had same problem like this, I just run one tank of fuel. When cutting...
-
That gets to the only thing that I ever said nice about the splined screws. Easier to keep the tool on one. Just don't get careless and...
-
If you’re talking about the red plastic caps, I pull them with a drywall screw, trim the tab off and put them back in. I’ve had a few...
-
The needles stay in place just fine with them off, but due to how small the needles are it can be hard to line up a flat screwdriver...
-
OOOh! Today I pulled 4 off two 2511T carbs and tossed them in the trash. Guess I'll be dumpster diving in the morning.
-
Well gents, got the grinder apart and changed the capacitor and it fired right up. When putting it back together somehow I broke the...
