Duane(Pa)'s latest activity
-
Yeah, I looked into timeserts, ended up going with a helicoil it off of Amazon for another job. They worked well for holding cylinder... -
On some cylinders from Husqvarna(like the 390?), Helicoils were already installed from new. This should be fine if installed correctly...
-
Duane(Pa) replied to the thread Ms362 exhaust leak..Threads in jug at exhaust flange. I think it’s 5mm. Watched video of timesert brand. Tools are expensive inserts are reasonable…
-
Should I admit to having put muffler screws on a hot stove element, before screwing them in? Yes pliers and a couple of room temp...
-
Use a Helicoil repair of your choice if in aluminum. You will end up with stronger threads than original.
-
Duane(Pa) reacted to jblnut's post in the thread SOLD MS261cm MMWS w/Sugihara LW bar **SOLD** with
Like.
What a nice looking saw !! Put me on the list if everyone above flakes out lol Edit: Joe is this your saw ? Dang that’s a good... -
Duane(Pa) replied to the thread Ms362 exhaust leak..Speaking of… what is the best plan for a stripped muffler bolt hole? Half the threads came out with the blessed lok tite (different...
-
Is it a plain 362 or C–M? Is it possible that it’s tuned too rich?
-
Duane(Pa) replied to the thread College football ball busting.I'll try to work up a tear... lol BTW is it stihl college if they don't go to school? It's ruin't if you axe me
-
I am assuming flat surface like the one that works on the Oregon grinders
-
Duane(Pa) replied to the thread CBN raker wheel.Will this have the shape of a raker, or flat surface?
-
I talked to Diamond; they are making some, with a 12mm arbor, and sending me one!
-
I have a mix of stock and ported saws in the fleet, more oil isn't a bad thing.
-
Duane(Pa) replied to the thread WANTED Stihl 024 or 026.Not mine...
-
Nothing wrong with that. Saber would probably be fine at 50:1. I just like extra oil even though it might not be necessary.
