Duane(Pa)'s latest activity
-
A Dremel is fine if you are touching up a chain, but the grinding wheels pack up too quickly to do a full-on sharpening. -
Duane(Pa) replied to the thread Chain Sharpening.I have a friend with a part time tree service. He uses a Dremmel. He can sharpen a long chain in a short amount of time. Usually...
-
Show us your CCC Racing Wiseco Piston and tell us a little about your build, be it a racer, milling or work saw I'll start out with the...
-
Eggshooter proved that a few years ago. Put several different oils onto a piece of shiny steel and set them on a shelf for a year in his...
-
It's probably obvious but it's the Husky 395 for me.
-
346, 365, 390, 7900, 500i
-
Duane(Pa) replied to the thread Randy’s Engine Repair.POS… word to the wise is sufficient. Can’t save everyone, but I can maybe save a few in here?
-
Duane(Pa) replied to the thread Randy’s Engine Repair.He screwed me big time. Like to get him in a dark alley...
-
Duane(Pa) replied to the thread UPCOMING MMWS Fall GTG October 24th and 25th.Gentleman posted that we’re at the 10 year anniversary of this forum. Randy had a pretty good run herding all the cats in and around...
-
Duane(Pa) reacted to cuinrearview's post in the thread UPCOMING MMWS Fall GTG October 24th and 25th with
Like.
The end results of that "for sale" thread, had very little to do with that thread. It was just the match that lit years of gasoline. -
Duane(Pa) replied to the thread T&S CZ223 review.I have no problem with the readily available 5/16" fine thread dressers. Hate the dust, but sounds like that is addressed with vacuum...
-
-
So my problem with the dressers is that they're single point and not the same as the ones for a Simington or Silvey, so can't just swap...
-
Duane(Pa) replied to the thread Definitive Dave...Discussion.I think it ought to be locked down or dumped. There's no way this doesn't get fixed. The timing is the only issue. But what do I know? I...
-
Duane(Pa) replied to the thread Definitive Dave...Discussion.Maybe edit thread title?