Dream's latest activity
-
I've added 3 more gaskets to my Mac 33B, Super 33, Model 39, Mac 35, and Mac 35A lineup for easier rebuilds... -
The CP55 is a fine saw when running properly. Very nice anti-vibe, just be careful with the lower mount as those could be a bit...
-
Awesome, both of my 10-10s are right hand starters!
-
got my first rh start mcculloch today!
-
Just spent some time adding some Gear drive gaskets to my site today.... 10 series and large frame stuff...
-
Recent donation. It was kept up pretty well, I will give it a good clean up and find a spot for it in the display. Mark
-
Need to pull this one apart tonight, has some play in the pto side,
-
Got a carb kit for the 640. Just need a few minutes to get it done.
-
Everybody must be working outdoors this week.... This is still the McCulloch Chainsaw thread. Cutting wood with my 1-46 several years...
-
Made the handle/Tank gasket, Cylinder gasket and End Cover Gasket for Griffin for this saw.... He sure did a nice job on the restoration...
-
The screw located near the throttle arm is the idle speed control, it goes through the body of the carburetor and actually contacts the...
-
Mark,here's what the SP60 has for a carb.It might be difficult to determine what it is.
-
Ed - I have some notes that tell me the early SP60 saws would have been equipped with a Walbro SDC50 carburetor that has the internal...
-
I went to put the ignition module on the J'red 535 yesterday & it's the wrong one.I had to buy another used one that should be the...
-
Glad to hear that you were able to get it dialed in!
