Recent content by down-n-dirty

Hi Shane, I have swapped out the pumps and clutch drum but the 455 pinion gear is rubbing on the pump cover and wearing out in a hurry. Did you have any issues with this? Thank you

Howdy Men, has anyone figured out how to replace the husky 450 oil pump with one from a 455? The 455 pump fits perfectly in the 450 case however I am tunning into an issue with the drive gear. They are completely different, so any suggestions would ber greatly apperciated.

Good evening everyone, I have three mac 10-10 auto cylinder oil tank units and they all have air leaks where clamshell halves join. Moto seal won't hold pressure, seems they all have imperfections in the mating surfaces. Has anyone tried to make some sort of super thin gasket to address this...

Good Morning, does anyone know the part number model number of a Hysky 55 clutch removal tool. I have run out of options trying to locate one of these for my Huskys. Thank you

Good evening, I am trying to run down a ball bearing #65044-S for my SEZ but am only having luck finding a 65044. Does anyone know if they are interchangeable? Also do you know of a compatible aftermarket bearing? Thank you

Thanks for the info, my oil caps have a removable plate in the bottom and accommodations for a duckbill under it. This is a screenshot of my IPL for 10-10 and 10-10A saws.

Thank you for the reply, The original check valve 86402 (duck bill) was completely gone so I haven't the foggiest what it looked like. Can't find any reference to the 86402 outside of Leons McCulloch literature IPL. This is for the oil cap so I am pretty sure the ones referenced for Poulan are...

Hey guys, does anyone know where I can find duckbill valves for 10-10 Automatic oil tank cap? Thank you

Thank you Mark, apparently the original ck valve has deteriorated and is completely gone. Have a good one!

Hey guys, I am currently rebuilding a Homelite Textron (Walbro) HDC-4 carb obtained off E-bay. I don't see any sign of a ck valve under the screen, nor is there any black residue from one that may have deteriorated. My question is do all Walbro HDC carbs utilize a ck valve, or are there...

Hey Mark, thank you very much for the excellent response, I haven't had time to respond until now but everything you said is golden. I did locate a 7 tooth clutch drum and sprocket (star type) which I had to press the bronze bushing out of the old one and into the 10608 and am back in business...

Would any of you fellows know the ID and OD of a Mac drum bearing #103688? I located an Oregon, 10624 clutch drum and rim sprocket .404-7 but the crankshaft on my Mac 200 is .625 while the ID of Oregon needle bearing is approx .585. It even states on the box that it will fit 105,125,200,250 etc...