Recent content by dmvaill

I was trying to prime it and no fuel was going in the primer bulb.

I have a 9010 blower that was running and now it won't start. I checked for spark and I replaced the spark plug and the carburetor. I also replaced the grommet and all hoses and fuel filter. After doing this , It started then stalled and now won't start again. Does anyone have any ideas?

Does anyone have the repair manual for MS 362C?

I am replacing my handle on my 3020 Trimmer, and I was wondering how to figure out where the 2 connectors go. one goes to a spade connecter and the other a ground I think.

I am just rebuilding a couple and have different frames and new Briggs engines to go on them. The recoil hits the frame unless you lift the engine, then you have an issue with fitting the pulley cover on.

Thank you for looking. That is all I found.

Does anyone know if there is a Mclane edger service manual?

I was wondering if I could get the Echo carb manuals also.