Had to watch frame by frame. Looked like Ron had him here, because the angle of the saw makes it look like he had it. But...
After further review!! Shawns straight cut ended up dropping first.
Great race!!!!! In real time? No one could tell who won!! No one!
And you can see the time on...
One more and I am giving up for the night. Some fast saws at this GTG and some cool cats that I got to meet and some to see again.
Hats off to you Ryan. For your first GTG that you hosted? You knocked it out of the park!
@Hedgerow told me that 2 years ago in Iowa. I said it several times yesterday
I only raced in the 5 cube. Let Levi run my 4 cube and he did a heck of a job.
Matt, you have raised one heck of a young man!
I wish I seen this thread about 3 months ago!! Took me 2 hrs to read and watch all the...
Then they should take a video of that saw boasting the 45%..
I just posted 2 videos taken 5 minutes apart. I just swapped stock muffler for a very generous muff mod and made sure it was still spinning 13k.
Pretty good numbers for a muff mod. Add a Good port job, and a good chain? Add a Great...
Do the math on these 2 vids. Same chain.. Just a muff mod. Same tune. Sounds different, but both were at 13,000rpm. Someone smarter than me figure the percentage. ;) That's not a better chain. So slap a good filed chain on there.
Stock
Muff mod
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.