David Young's latest activity
-
An old trick for easily flattening out the upper transfers and also squaring the corners is to use a couple stacked dremel type abrasive... -
If chainsaw sniffing has gotten you in to trouble financially, caused trouble with coworkers, or pushed things more important to the...
-
David Young replied to the thread SELLING NOS Dolmar 109-115 cylinder kit and 2x crankshaft. 116si piston, 120 clutch, 5000 crankshaft.2.Dolmar 115 44mm closed port cylinder from a new saw that was made to bits and parts while ago(~10 years) 50.-$ plus shipping Im...
-
David Young replied to the thread SELLING Huski and Jred parts.perfect I'll take it...
-
David Young reacted to Stump Shot's post in the thread Relevancy of Husqvarna 570 and 575xp loggers junk saws with
Like.
The more and more saw models are losing factory support, the more it'll be getting all MacGyver meets Mad Max up in here. -
When I have encountered this very problem, a little more rich on the low side and a little more RPM on the idle screw fixes it 95% of...
-
David Young replied to the thread Rich coming off of WOT.Honestly I’d try another carb before I went too crazy. You know it is in the carb bc the old one works.
-
Thats what I thought. And these are all good points. I have already checked all these things. Ive ran into carb issues before but not...
-
A video might help diagnose it as well
-
More often than not, I see people running them overly rich on the H jet when they do this. It will wet the case and transfers so that...
-
David Young reacted to Firewood Hoarder's post in the thread 359 case repair advice needed with Like.
I've welded up similar oil-soaked stuff, and the biggest thing as others have said is cleaning and surface preparation. Light...
-
I've used ERAZ92A filler on a couple saw cases, but I'm not an expert. I set my tig welder to 150 but then used the pedal to control...
-
I didn't find it too difficult to weld. I did heat the area pretty good a few times to sweat the oil & junk out of the crack. I did a...
-
David Young replied to the thread Rich coming off of WOT.You are in the right range for pressure. The pressure can tune the ramp in from low to high, the lever height needs to be close to what...
-
I prepared cases in blasting cabinet with aluminum silicate, then put them in ultrasonic cleaner for half an hour, dishwashing liquid...