David Young's latest activity
-
I've used ERAZ92A filler on a couple saw cases, but I'm not an expert. I set my tig welder to 150 but then used the pedal to control... -
I didn't find it too difficult to weld. I did heat the area pretty good a few times to sweat the oil & junk out of the crack. I did a...
-
David Young replied to the thread Rich coming off of WOT.You are in the right range for pressure. The pressure can tune the ramp in from low to high, the lever height needs to be close to what...
-
I prepared cases in blasting cabinet with aluminum silicate, then put them in ultrasonic cleaner for half an hour, dishwashing liquid...
-
David Young replied to the thread 359 case repair advice needed.I haven't done mag welding personally. Its described as like welding aluminum but trickier. I know it is best to clean away the paint...
-
Similar problem here. Bought pile of parts and there was 357XPG carcass with both case halves cracked. Flywheel side is easy one, but...
-
Pop off at 13 to 14 psi
-
David Young replied to the thread Rich coming off of WOT.it sounds like the main jet with those jet settings. What is the pop off pressure? does it reseal after pop off? the carb venturi...
-
I don't think you need the gas tank but I can try swapping my handles if you would like to confirm
-
David Young reacted to Mastermind's post in the thread Post up your ported cylinder Artwork with
Like.
Looking good. I don't use a single or double cut burr to tidy up the corners of the upper transfer ports. I use a 180 grit diamond burr... -
David Young replied to the thread jonsered 2260 parts compatability.local, former jonsered dealer said to put the 562 stuff on. I would need the gas tank, top handle also, because of the angles involved.
-
Can put 562 handle on 2260 tank because I was going to swap mine over but didn't because I didn't like how brake handles lined up with...
-
David Young replied to the thread Rich coming off of WOT.the metering lever is hanging up some how. It is also possible that the check valve in the main jet is not sealing well.
-
David Young replied to the thread Couple of my 545/550mk1 builds.Is the saw muffler modded as well? I think looking at the differences between v1 and v2 gives us some great insight to what they found...
-
Just got one last week. Not sure why I haven't gotten a few more. I guess cuz my 572 is a worthy replacement.