David Young's latest activity
-
-
That's the @dall signature series. I've been told they were only available in limited quantities at WV truck stops.
-
David Young replied to the thread Show off your muffler mods.I've never had a problem. you could also make sure the piston closed off the port if you are worried. a stopper or plug isn't a...
-
This $220, filthy faded screamer has a muffler that is so rusted, you can't remove the bolts. Stripped out trying. Gobs of compression...
-
if you are concerned of getting something in there you could put a rubber stopper in there
-
I never worried about stuff getting in when the saw isn't running. I have heard of mice and mud daubers getting in of stored in a barn.
-
David Young replied to the thread 261 with a Farm Boss bar?.the first two honks, come on man keep up.
-
This is an example of a bar where imagery is important to me.
-
David Young replied to the thread 261 with a Farm Boss bar?.did any of you get one of these on your new stihl? the thing that bothers me is the green dots.
-
-
David Young reacted to upstateamish's post in the thread Hybrid clonesaw 365 with a 390 topend - aka the "86'r from youtube" with
Like.
Tore it apart tonight. Found that the case bolts were slightly loose which probably contributed to the oil leak. Here's the rough... -
David Young reacted to Outback's post in the thread Hybrid clonesaw 365 with a 390 topend - aka the "86'r from youtube" with Like.
This is going back to the beginning, but I was curious why you picked a 661 piston for your p1 saw. Was that what you gleaned from the...
-
David Young reacted to upstateamish's post in the thread Hybrid clonesaw 365 with a 390 topend - aka the "86'r from youtube" with Like.
my harbor freight caliper rough measurements are: roughly 20mm in height the top shaft portion where the oil pump gear rides: 19.31mm...
-
David Young reacted to upstateamish's post in the thread Hybrid clonesaw 365 with a 390 topend - aka the "86'r from youtube" with Like.
I was able to get some stuff sort of tuned on the 2nd prototype and get some video. As I'm learning how to do video editing I got pulled...
-
David Young reacted to upstateamish's post in the thread Hybrid clonesaw 365 with a 390 topend - aka the "86'r from youtube" with Like.
Yup 💯 I did clearance the top cover in this area, but as you note the higher jug means that the wiring gets pulled and could be pinched...
-
David Young reacted to upstateamish's post in the thread Hybrid clonesaw 365 with a 390 topend - aka the "86'r from youtube" with Like.
you're correct I modified the corner so theres no wire rub Muffler bolts up without issue (I'll be adding the addtional opening on...
