cuinrearview's latest activity
-
cuinrearview reacted to full chizel's post in the thread Not so pros 4 new and without politics or drama with
Like.
Whats up bishes. Its been a while, i’ve been busy with life and kids chit. -
cuinrearview reacted to huskihl's post in the thread Husqvarna 562xp air leak driving me mad with Like.
I don’t think it will matter with just a gasket delete, but you can check the front left where the transfer cap screw is close to the...
-
It's all good, there have been many times I have replied to a post and then as I reread it see that I totally missed the point or asked...
-
cuinrearview replied to the thread Husqvarna 562xp air leak driving me mad.I seem to remember seeing something @huskihl wrote about some interference around the exhaust side of the cylinder after dropping it...
-
cuinrearview replied to the thread HELP! 024/034 Stihl values.
-
-
I hear ya but... As my dad often said "let your conscience be your guide" Nobody (really) knows dick about china alloy. In other words...
-
cuinrearview replied to the thread G111/200t base.I'm no expert, but doesn't cutting the base make the exhaust lower? Semantics I know, but anyways... I don't think I can recall seeing...
-
cuinrearview replied to the thread HELP! 024/034 Stihl values.The 024 is a super too.
-
cuinrearview replied to the thread HELP! 024/034 Stihl values.I will give you $200 for the 034 if you do it.
-
cuinrearview replied to the thread Not so pros 4 new and without politics or drama.Towing husqvarnas? Asking for Dallas.
-
cuinrearview reacted to Kiwioilboiler's post in the thread Not so pros 4 new and without politics or drama with Like.
Morena E Hoas.
-
cuinrearview replied to the thread Not so pros 4 new and without politics or drama.
-
-
cuinrearview replied to the thread Not so pros 4 new and without politics or drama.Good morning folks. It dropped below freezing last night, and the taps were still trickling, so it continues... I'm taking the...
-
For occasionally use that I'm going to do, yes. For professional use, probably not.
-
cuinrearview replied to the thread Stihl MS311 vs Echo CS-590.Knowing this, do you trust their bearings? Seals? Cylinder plating?
