Recent content by Coop The Cutter

Not my work, just wondering what the professional opinion is on this 500i port job?

Couple decent ones on this last job

Sure if you'll cover the extra cost (if any) involved

Lightly used 661 clutch cover with rubber piece. $55 shipped to the lower 48

Brand new 500i clutch cover with rubber piece. 40$ shipped in the lower 48

That particular tree was cut with skip chain, but usually I run Stihl full comp full chisel round. I think 33RS? I do a lot of bore cutting so typically go through a couple tips over the life of a bar

Decent sized Red Oak I swung around to try and avoid a few save trees. Top busted a little but overall it was a success

I've noticed all the big chainsaw channels on YouTube are run by guys who don't seem to have a very good reputation in this community. My question is, are there any legit chainsaw builders who post detailed videos on YouTube or other social media?? And if not, why not? Some of you guys post...

Couple shots from last week

***1 set is sold*** 2 sets of Egan dawgs that I bought. Fits Stihl 044/440/441/462/500/661/064/066/660 Never used them they are too beefy for my East Coast trees. $25 EACH plus the ride

If you search his name on here you will see he has a not so stellar reputation. Lots of better builders out there

Most people need to learn proper chain sharpening and bar dressing more than they need extra power

Well here's one you don't see every day... Wind blew this tree clean off the stump almost 180° onto the excavator. It was 100% my fault as I never should have been cutting this close to a piece of equipment unless said equipment was pushing the tree. Fortunately nobody was hurt and the only...

Diggin that verse on the air filter, GLW$!!!