Recent content by Cjone

No, dont have enough knowledge of these folks to do that. Heck i have just started taking my own advise i gave randy years ago. Then he jumps into this and takes more time from himself. Just too nice for his own good. Cj

The only people you should have to moderate are YOUR mods. Let them swing the hammer for you and you just adjust them a little once in a while. Stop taking all.the responsibility for stuff that is a job. If you dont have enough help recruit more!! Cj

I have a 346 and a 562 both heated. I was going to have a 372g built but i dont need to cut in winter anymore, so kevin is building me a red headed 372 as a play saw. I would say the 562 is my faviorite heated saw because of how it runs on the topend. Cj

My reputation means more to me than money. And I think [hope, try my hardest] that this is true. It has cost me quite a bit but i would rather lose a few dollars making something right even when it was to begin with than having some one talk bad about me. I think i only have had maybe 2 times...

If the carb has double floats check that one is not sunk. Common issue. Cj

I honestly can say that I won't live long enough to run any saw more than a 272/372. In the 12 years or so that I cut pro I had 4 272's and at least 6 or 7 372's. And by far they were the most trouble free saws. 1 failure when a intake clamp was junk. A few minor things like muffler bolts...

I'll have to agree with stump, buy a 372 before there gone. They cut good, feel good in your hands and give very little trouble. Cj

Hey steve! I have been very happy with my everlast welder. I actually sold a sa200 and a g8000 because I can run anything I need off of 2 2200 hondas and my 200 everlast stick on 120v. No more needing equipment to load the welder up! Cj

Good to know. Both of my new 2200's are on the recall list from the fuel shutoff I believe. Still no parts available. Nice huh, 2k worth of generators you are not supposed to use. Yea that is going to happen. Cj

Yep, a small section of pellet stove double wall pipe or the same from a gas stove. The double wall doesn't get very hot at all. Gives something to hook to also. Cj

It looks good, but I would get some clearance around the exhaust pipe and the combustible wall. Just like with a wood burning stove going through a roof once you load that generator it will build alot of heat and have a good chance of setting the wall on fire. A double insulated pipe like they...

The new 2200 have the 120, I remember now. The front led will flash 1-5 depending on the hours on the unit. 1 is 100 2 is 200 and so on. They last a long time if the oil is kept changed. Cj

Howdy, i can't say as I have never seen a.bad one. My 15+ year old one still ran like new when I sold it. Still does (buddie has it) with the original spark plug. I believe the engine is a gx100 or 120. Popular in compactors. Cj

Hard to find a good shop anymore, main reason I do what I can myself. Honda uses a crome top ring and they need a very fine finish along with the oil control rings. If I would not have had the parts into it already I would have just picked up a gx390 long block and put a generator crank in it. Cj

I picked up a EU6500 that had 131 hours on it. Hard to start and would not pull a full load once running. Figured it was the normal gummed up carb from sitting. The engine also had more noise from the valve train than normal and a knock that is typical from a 13hp Honda. Sooo. first cleaned the...