CJ Brown's latest activity
-
CJ Brown reacted to upstateamish's post in the thread Hybrid clonesaw 365 with a 390 topend - aka the "86'r from youtube" with
Like.
my harbor freight caliper rough measurements are: roughly 20mm in height the top shaft portion where the oil pump gear rides: 19.31mm... -
CJ Brown reacted to upstateamish's post in the thread Hybrid clonesaw 365 with a 390 topend - aka the "86'r from youtube" with Like.
So the tool apparently was delayed in shipment but I haven't been idle. tonight I built a new crank sleeve bushing. (something which may...
-
CJ Brown reacted to upstateamish's post in the thread Hybrid clonesaw 365 with a 390 topend - aka the "86'r from youtube" with Like.
Ok, some tweaking of the carb and it runs! (and honestly, I think pretty good) but the temp is dropping and it's super windy in just a...
-
CJ Brown reacted to Shane¹'s post in the thread Hybrid clonesaw 365 with a 390 topend - aka the "86'r from youtube" with Like.
I know the 153 compression height is taller than 143. Also there is 143 pistons that are not full circle design too. I will look through...
-
CJ Brown reacted to mgr1's post in the thread Hybrid clonesaw 365 with a 390 topend - aka the "86'r from youtube" with Like.
Dolmar 143 piston is 55mm 41,8mm long 12mm pin Compression height 16,6mm. Full circle design.
-
CJ Brown reacted to Shane¹'s post in the thread Hybrid clonesaw 365 with a 390 topend - aka the "86'r from youtube" with Like.
Just curious if you have looked into measurements of a dolmar 143 and 153 pistons? They are both already 55mm. Both do have a 12mm pin...
-
Modified this 133/ 143 carb for a 9000 and started making another to try on my hybrid build. Welded a worn out zama throttle shaft end...
-
It is a nice kit, got it on AZ. The plastic filler sticks that came with it aren’t great but the stainless mesh and the tools work...
-
yes, the so called bushing is the cam lobe for points ignition they are slightly tight on the shaft but come off.
-
Finished up my cheap 353. Has an AM clutch cover because it didn't come with one. Put on a used muffler, carb kit, metal intake clamp...
-
246 - 95, paid $100, only defect was a broken cord. So it has been run rich mixture, guess its sprocket is on first. A good basis to...
-
I couldn’t wait to share my newest,coolest find with you guys. This is a pristine example of the W.German 024AV. W/HEAT! I didn’t...
-
I’m good for the same offer. Here’s a Dolmar cylinder I did last night. Trust me.. this isn’t coming out. On the 10mm holes and larger...
-
If you want to post the cylinder and valve to me (not the whole saw) I'll have a go at putting an insert in, at no cost. I have some...
-
So quite a while back I had posted a "wanted" ad looking for an early 357XP piston. The first couple years of manufacture of the 357XP...