CJ Brown's latest activity
-
CJ Brown reacted to upstateamish's post in the thread Hybrid clonesaw 365 with a 390 topend - aka the "86'r from youtube" with
Like.
Ok, some forward progress, I have the short block together (well, as far as I can get tonight) - new crankshaft bushing made - piston... -
CJ Brown replied to the thread Shindaiwa 488 Rebuild Woes.Use a flat screwdriver or small flat punch and slightly fold the metal edge of the seal in toward the crank shaft all the way around the...
-
It's pretty easy if you have a decent seal puller or can make one. I've made a variety of seal pulling tools with old flat head...
-
Phase 2 is making some progress recently. I was able to use my Struck mini dozer to place 5 truck loads of sand trying to get the site...
-
I find some hidden errors when I go through them part by part before assembly. Good thing I have something similar lying around, even...
-
-
2100CD , top end, seals , carb kit ,
-
CJ Brown reacted to old_sir_henry's post in the thread DOLMAR/MAKITA The Official Sachs Dolmar Dolmar Makita Dolmar Chainsaws Thread with Like.
Originally thats the handle-heating switch on the later models. However it is simple to connect that switch with the ignition coil to...
-
You forgot that ported saws are much more fun to run!
-
well, i think you are ignorant. the fact of the matter is i can sharpen a chain just fine but at the end of the day, a good ported saw...
-
CJ Brown reacted to upstateamish's post in the thread Hybrid clonesaw 365 with a 390 topend - aka the "86'r from youtube" with Like.
Initially there was some slight rub on the crank lobe while turning things over by hand with everything dry. However, after messing...
-
CJ Brown reacted to upstateamish's post in the thread Hybrid clonesaw 365 with a 390 topend - aka the "86'r from youtube" with Like.
Rough measuring showed the connecting rod sits about 1.5mm below the end of the crank lobe at BDC. as I got into it, it turns out I did...
-
CJ Brown reacted to upstateamish's post in the thread Hybrid clonesaw 365 with a 390 topend - aka the "86'r from youtube" with Like.
Prototype number 3: I'm happy enough with how the prototype #2 is running (and it's been a bit rainy so I haven't had much time to...
-
CJ Brown reacted to upstateamish's post in the thread Hybrid clonesaw 365 with a 390 topend - aka the "86'r from youtube" with Like.
Over my lunch break I got some vid of the prototype 2 run against my 500i with a west coast air filter. Same length bar, same chain...
-
CJ Brown reacted to upstateamish's post in the thread Hybrid clonesaw 365 with a 390 topend - aka the "86'r from youtube" with Like.
ok, cut a bit on my lunch break. Was fighting the saw overfueling at WOT (which you can hear a bit in the above video) it would barely...