chipper1's latest activity
-
chipper1 reacted to Duane(Pa)'s post in the thread Simington / Silvey Square Chain Grinders Tips/Tricks/Secrets with
Haha.
I’m getting old and repeating myself 😳 -
-
Sold the Simington :p
-
Never tried square grind. Anyone interested in selling a couple loops in 3/8-.050-72 drive links to Texarkana ?
-
chipper1 reacted to Khntr85's post in the thread WANTED Ms261c oem piston and cylinder new or good used condition with
Like.
Ok I will get with ya, had to take a test for my work and it’s HARD and has been eating whatever brain space I have left lol!!!! -
chipper1 replied to the thread WANTED Ms261c oem piston and cylinder new or good used condition.Did you figure out which one you have. There is an earlier one with a cylinder bore that is straight up and down, and a newer version...
-
I bought several of these 592’s from a local logger. This one runs, but it runs rough. It will rev out but idles low then dies. Piston...
-
chipper1 reacted to Duane(Pa)'s post in the thread Simington / Silvey Square Chain Grinders Tips/Tricks/Secrets with Like.
Watch these over and over. there is a lot of crossover between 450 and 451. https://simingtonchaingrinder.com/how-to-videos/
-
chipper1 reacted to Wolverine's post in the thread Simington / Silvey Square Chain Grinders Tips/Tricks/Secrets with
Love.
Don’t be mad at the machine, it’s capable. -
chipper1 reacted to Khntr85's post in the thread Simington / Silvey Square Chain Grinders Tips/Tricks/Secrets with Like.
I will definitely do that with the motor
-
chipper1 reacted to pbillyi69's post in the thread Simington / Silvey Square Chain Grinders Tips/Tricks/Secrets with Like.
you might have to re-shim the motor. the face of the arbor should be half and inch from the bottom of the frame. the motor gets...
-
chipper1 reacted to Khntr85's post in the thread Simington / Silvey Square Chain Grinders Tips/Tricks/Secrets with Like.
Ya I tried it some the other day, need to measure with it agian…I just needed some sharp chains so I went to the square jig… Need to...
-
chipper1 reacted to K Mueller's post in the thread Simington / Silvey Square Chain Grinders Tips/Tricks/Secrets with Like.
Does yours have multiple thrust washers on the swing arm? Should be able to swap them around to raise or lower the arm?
-
chipper1 reacted to Khntr85's post in the thread Simington / Silvey Square Chain Grinders Tips/Tricks/Secrets with Like.
Also I don’t know who commented about the dressing the wheel is very important on the 450 but I can believe that….when I dress the side...
-
chipper1 reacted to Khntr85's post in the thread Simington / Silvey Square Chain Grinders Tips/Tricks/Secrets with Like.
So do you have to shim the motor or what…I was so pissed the other day I had to walk away….i thought it would be way easier setting up...
