chipper1's latest activity
-
If you can get a lift to it, I wouldn’t bother exploring other options IMO. Obviously start working it shorter from your high risk side... -
I haven’t got up close to it but I’d expect it to separate. Hence the chains and binders down low, and some rope up high. I’ll have to...
-
Will they hold together? Or are they essentially just separate stems growing tight along side of each other. I’d worry about them...
-
Definitely not to be trusted. I’m thinking turn them into a bouquet and use the favorable leaners to balance the unfavorable. It’s...
-
I'd evaluate the unions at the base carefully - you might be able to fall the spars away that have favorable leans.
-
I sure as heck wouldn’t climb it. I think maybe I can get the lift to it. I’m thinking chain it together and pull it away from the house.
-
How dead is it? Is it getting easy to break limbs off? Looks like pull and cut the spars going away from the structure and then maybe...
-
I have my ideas but fire away, this should make for some good discussion @Catbuster @Woodpecker @Loony661 @Normzilla @chiselbit...
-
I'm going to cut cedar tomorrow. I am bringing a couple saws but I will have different roles for the 545 and 550. I will have the...
-
Without AT keeping saws running that otherwise, shouldn't have been, the heat wouldn't have been so excessive. It did its job too...
-
Don't overthink airleaks. Be thorough down to the crank seals, but don't worry about splitting the case if the crank shaft is tight and...
-
I have some to build, any building tips? things to watch out for? Porting suggestions. the package was the right size but had gremlins...
-
Today I swapped a coil+solenoid on an ebay 545 runner. To my surprise, the saw had an AT-12 on it... score. Anyway, replaced the seals...
-
Without a doubt. They were really forward thinking towards the end-user experience in the 50cc category. The tape I have is from the...
-
chipper1 reacted to David Young's post in the thread Relevancy of Husqvarna 570 and 575xp loggers junk saws with
Haha.
I bet you could get it for a bargain. Who doesn't like a bargain....
