bwalker's latest activity
-
bwalker replied to the thread Oil questions....I would suggest you just run your equipment and not look at the plugs or obsess about the oil. Or just ditch that 4mix crap and get... -
Could check with AI and see what they say. Never know when you’ll find an opinion that agrees 😊
-
bwalker replied to the thread Oil questions....Spark plug heat range does not change how clean the plug runs... opening the gap did nothing for you but stress your coil more. Red...
-
In a diesel engine, the oil is clean only a short time after replacement 😎
-
When did this forum get more trolls than Denmark. Your engine was probably exposed to old gas that you don't have the self respect to...
-
bwalker replied to the thread Oil questions....Again... heat range doesn't change how clean the plug runs.
-
bwalker replied to the thread Oil questions....If its plugging fuel filters it might.
-
bwalker replied to the thread Oil questions....Yes and those deposits can cause pre ignition. It's not doing you any good and your risking damage. Mystery oil is garbage snake oil too.
-
bwalker replied to the thread Husqvarna 564xp (g) fuel inject.Good to know there is an XPG wrap.
-
I have 4 days of work with my 564, until now it's running flawless.
-
bwalker replied to the thread Oil questions....Adding a zinc based additive is not a good idea at all.
-
bwalker replied to the thread Oil questions....Yes, it most certainly is. Two stroke pistons always run hotter than four strokes. It certainly has nothing to do with the sparkplug...
-
bwalker replied to the thread Oil questions....Tuning influences that sort of thing as much or more so than oil or oil ratio. Increasing your spark plug gap just increases the stress...
-
bwalker replied to the thread Oil questions....Here is a plug ran on Redarmor from a Redmax Blower and a Redmax Trimmer. I believe these had a partial season of my sons lawn care...
-
-
bwalker replied to the thread Oil questions....Spark plug heat range doesn't measure what you think it does. Its measures how hot the electrode runs, not how hot the combustion...
