bwalker's latest activity
-
you are correct that lowering the cylinder changes the timing on all ports. i'll do my best to explain stratto's in a latter video... -
bwalker replied to the thread Oil questions....Most oils that combust cleanly with sharp tuning dont have much smell. Castor oil has that sweet racy smell because its not completely...
-
no not all modern mix oils are good. especialy, dont use stihl oil!
-
Dominator, Saber, K2, Motul 710, Castrol Go are all very clean burning. I haven’t seen any buildup inside the exhaust port of a saw...
-
bwalker replied to the thread Oil questions....My preference is for a bead blasted intake and a mirror finished exhaust port. I am not suggesting this is the best way. Its just my...
-
bwalker replied to the thread Oil questions....In the first place be aware that the term alkykate is a blanket term for a variety of products. A look at the MSDS I posted shows this...
-
bwalker replied to the thread Oil questions....It is true that the lubricity standard for FB, FC,FD is the same. Its a mistake to also believe that FC and FD oils dont exceed the...
-
bwalker replied to the thread Oil questions....I posted the MSDS....
-
bwalker replied to the thread Oil questions....Just about any aircooled oil is better snd cheaper than Ultra. You want to waste money on low quality, yet high priced crap, have at it.
-
bwalker replied to the thread Oil questions....A properly tuned saw burns oil just fine or you would have a mess in your muffler and even worse internally. A 20 degree swing in...
-
bwalker replied to the thread Oil questions....Motox mix may be 99.99% alkylate, but others are not. Its mixed with Ultra oil, which is garbage so its not the finest. I am well aware...
-
-
bwalker replied to the thread Oil questions....Your energy figures must not be including the energy present in the oil, which has a higher BTU number than gasoline.
-
bwalker replied to the thread Oil questions....This is spot on and a reason why Autotune and Mtronic are very beneficial to the average guy.
-
bwalker replied to the thread Oil questions....We dont add aromatics to pump gas...we take them out in fact. Some of the cand fuel actually has aromatics. Benzene, Toluene and Xylene...
-
bwalker replied to the thread Oil questions....There isnt much to elaborate on. If you're tuned rich you will burn dirty. Also using a high viscosity, high temp oil doesn't help either.
