bulletpruf's latest activity
-
Not sure if a gasket made out of an aluminum can would be a happy medium between the factory metal gasket and no gasket. Might be worth... -
When I do circlips I check each side bout 10 times for some reason. Twice would be enough.
-
bulletpruf replied to the thread $200 Running MS660 - Now What?.Yep, that would have been an exceptionally painful mistake.
-
bulletpruf reacted to Powerstroke Cowboy's post in the thread $200 Running MS660 - Now What? with
Like.
Well, now you can sand the jug down! LOL On a more serious note. I'm glad you found the clip and had enough sense to check your work! 👍... -
bulletpruf replied to the thread $200 Running MS660 - Now What?.Had a bit of a scare this morning. Was getting ready to use the blower to clean off the garage floor and saw something familiar - one...
-
bulletpruf replied to the thread $200 Running MS660 - Now What?.Good point. I just went with the factory metal gasket. Saw the comment from @Powerstroke Cowboy after it the jug already installed and...
-
"MOST" Gasket material is petroleum resistant, Cereal/beer boxes breakdown after time. (My thought for the day).
-
bulletpruf reacted to jacktheripper's post in the thread SOLD Snelling-Built NOS 044 - Ran once with Like.
I have a beautiful example of an 044 for sale. I bought this saw from a member/collector on here, and have realized that I don't really...
-
I have a pretty little 024 for sale. The saw was purchased from the original owner, who says he bought it in 1991 to clear a stand of...
-
I have an 038 Magnum II that was pieced together with the help of a saw that I bought from @how57 and parts from @Woodwackr. It has...
-
bulletpruf reacted to Powerstroke Cowboy's post in the thread $200 Running MS660 - Now What? with Like.
Sand the base of the jug down. A flat surface, some good sandpaper, elbow grease and patience will yeild great results. I mic all four...
-
For acid rinses better to use: 1)Baking soda, 2) water
-
bulletpruf replied to the thread $200 Running MS660 - Now What?.OEM piston finally showed up and I checked squish with no base gasket - .012" - too tight. The factory gasket is .019" so I could do...
-
-
064 purchased new in 1988, just acquired it from the original owner.
-
Picking at the 647G some more. Drained the molasses out of the oil tank and got the pump freed up. Couldn't roll the chain by hand...
