bulletpruf's latest activity
-
Cleaned up my $30 Facebook find 32” light bar. Scotch brite pad on a Roloc disk in the die grinder to remove the rust, dressed the rails... -
Good catch! That could have turned out badly.
-
bulletpruf replied to the thread What's on your bench?.Melted 15-50 outlet for the Long Haired General's plug in hybrid. After I removed, disassembled, and diagnosed the problem (the the...
-
-
I went through a box of Hammer bullets awhile back. They were accurate as the lead center target bullet I was loading at the time...
-
Lead free projectiles. I've visited with Steve in the past. Never did try any of there bullets though. Cutting edge out of PA makes a...
-
Since here in the great state I shoot barnes bullets and they do well. I have been wanting to try hammer bullets but have so much Barnes...
-
Something I need to get doing as well. Switched powders and need to get a new load developed with the new powder. R26 became hard to...
-
bulletpruf replied to the thread Mildly porting a 026.I'd definitely do a muffler mod - gut or drill out the baffle and add another port. From there, I'd do a base gasket delete or use a...
-
The electronic (solid state ignition) saws have a symbol after the serial number - I think it's a plus sign inside a circle.
-
The 592 is a good machine, stock or ported so I don't think you'll be disappointed. The 056 Super is a pretty good runner in stock...
-
bulletpruf replied to the thread What's on your bench?.Doing load development for my .308, 168 grain Sierra Match King, Varget powder. Best results so far are at 45.1 grains.
-
-
bulletpruf replied to the thread What's on your bench?.Roll cage going in the race car - '72 Javelin for the 24 Hours of Lemons.
-
-
bulletpruf replied to the thread What's on your bench?..308
-
Good lookin setup. What chamber?
-
bulletpruf replied to the thread What's on your bench?.About 1/2 MOA if the shooter (i.e., me) doesn't dork something up.
