High Quality Chainsaw Bars Husqvarna Toys Hockfire Saws

blades's latest activity

  • B
    blades replied to the thread No replacement for displacement!.
    at 74 my go to units are still the 64xx and 79xx Domars, when the big nasties show up then it is my 084 with either a 42" or 60" bar...
  • B
    blades replied to the thread Chain oil test.
    rape seed oil ( canola) When it gets hot it changes( breaks down) then when it cools its like epoxy to get it off. additionally it...
  • B
    blades replied to the thread Electric radiant ceiling heat (???).
    I remember those programs and then came the 70's and massive increases in electric bills. ( on going to this day).
  • B
    blades replied to the thread Picking up my new Dodge Ram today.
    carfax would likely not show any of this. it hasn't left the dealer lot yet., other than the title change.
  • B
    blades replied to the thread Picking up my new Dodge Ram today.
    Just so you know they have been haveing problems for quite sometime with the totally integrated power modules, ,known issue in the...
  • B
    blades replied to the thread Picking up my new Dodge Ram today.
    no way in he double hokey sticks I would take re- delivery of that unit. Every module and sensor array has likely been stressed to the...
  • B
    blades replied to the thread Our 243 strory..
    Addenum: the knocked scope was apx 6.5ft to the right at 100 yds on the first shot , second one was about a little closer about 4 ft...
  • B
    blades replied to the thread John Deere D110 belt tensioner issue.
    I will have to get the info from the sleeve the belt was in ( which I saved for getting a new later) .
  • B
    blades replied to the thread John Deere D110 belt tensioner issue.
    Up date on Jd belts for the mower blades. I have a JD la120 ( same 42" deck as 110 gone though a mess of belts over the last couple...
  • B
    blades replied to the thread Chisel bit CBN.
    yes been that for a very long time. although the delay time is shorter now.
  • B
    blades replied to the thread Crooked Knife?.
    BIg Old buzz saw blades get work hardened ( not to mention excessive heat which also hardens the steel, if run dull) at this point they...
  • B
    blades replied to the thread Crooked Knife?.
    Band mill blades are about .063 thick, then it depends on the particular type , hard edge flex back, hard edge hard back ( spring steel...
  • B
    blades replied to the thread Crooked Knife?.
    I make knives out of old circular saws every so often . The metal is a high chromium content. you can cut it and file it easily...
  • B
    blades replied to the thread Official whats you temp this morning thread.
    35F 6:30am
  • B
    blades replied to the thread How long to wait before tracking a deer (crossbow)?.
    I wait about 1//2 hour or so
Show older items
Top