Bigmac's latest activity
-
10 speed transmission parts. And yes, over-complicated. -
-
Brought an old Dog home. Fuel tanks have a build date of 11/56.
-
A parcel arrived from the USA or Japan 😉 15$ Someone installed 2 different brushes, one had to be knocked out 🤨 see deep inside the...
-
Absolute chaos. Switching jobs in the middle of completely rewiring my Jeep. Bench, welding table and home tool boxes are covered in...
-
Did a few more cuts this evening. It's oiling well enough to keep the bar from getting hot in one 10" hardwood cut. Warms up cutting...
-
I put a side tensioner on mine and an 18".050 3/8. 7 tooth rim sprocket and Picco Super full chisel. With the muffler opened up...
-
I find some hidden errors when I go through them part by part before assembly. Good thing I have something similar lying around, even...
-
I've seen sparks piss reving a ms261 at night to get the mtronic to reset. It sent a pretty solid stream out. It was a high hour saw...
-
Bigmac replied to the thread What's on your bench?.Ya that’s on the list too, just taking it step by step. Thanks for the advice. Have an ms180 to do as well, it runs ok stock, but have...
-
I gave mine a mild timing advance on the flywheel (after mm and adjustable carb) it improved throttle response without being too crazy
-
I didn’t buy this today, but it’s my latest cool buy. @Woodwackr really hooked me up on this one. Came with several chains and two bars.
-
Bearing/ Seal driver ,
-
2nd screen for my laptop. Makes writing invoices a lot easier.
-
As per title what did you buy today , for me today it was something I have been looking for for 5 years an 18 inch tsumura light bar for...
