bigbadbob's latest activity
-
Finally was feeling well enough to machine a 7900 jug. -
This is a TS350 if I can read it correctly, points ignition. Cleaning the old concrete off these is a chore. It will look much better...
-
Tried to use a Volvo as a cheater pipe but the wrench broke.
-
It still needs a lot of work, but it’s finally running and driving.
-
Specs are 15.5K, personally I feel they tune nice on 15.2K, 4 stroke, and i kinda like to be a tad on the safe side.
-
Euro muff. Mmmmmmmmmmmmm
-
Be glad you don't have the European muffler because then the entire muffler is filled with the pattern, a proper MM on them requires the...
-
We do have expensive hobbies :p
-
3 phase motor on my lathe failed me...stuff on several benches. I was in the process of tumbling the fuel tank for my buddies 200 amp...
-
Not sure if this helps, but I rebuilt a ts360 (same engine, cases, etc but different plastics and air filter) and it didn’t have the air...
-
We got hammered pretty hard again with some rain and wind. This was 3 days rain,, bust mostly yesterday! This is about 1/8 mile away...
-
-
Weaverville does. Junction city is 8 miles west of Weaverville. I worked at that mill for a few years in the early 2000s..
-
Junction City California. Flip property..
-
Little excavator work today. I should’ve taken a before pic… it was a mess of old concrete and junk.
