bigbadbob's latest activity
-
I did go a little bit crazy on them. The metal worker in me kept raising the bar, this is as high as I can reach without putting my... -
I should have added that they look too nice to be clutch tools.
-
A customer thought his 461 would run better if the H screw was turned in a couple of turns. As he found out, that was just a temporary...
-
I have the clutch tools, You source the stockings - lets become legends! 😎
-
I started just making my own 79xx clutch tool, the prototypes were ugly and the first version skinny. Then I made 3 Husqvarna versions...
-
I coulda sent you a stud :p
-
A lot nicer than the GENUINE HUSQVARNA OEM one I have! Are these stocking stuffers? 😁
-
Those are clutch removal tools. :thumbsup: Heavy duty, solid steel milled.
-
If the case surfaces are good, bare is as or more reliable than with sealant.
-
Those little shiny hanging down things? They are my circlip installers for piston pins. 9-13mm I need an 8 to have a complete set (I think).
-
My bench is so crammed I can't sit on it. They need sharp burs knocked off.
-
I also went through my new barn find white top 61 practica. I removed the muffler baffle, replaced the coil, rebuilt the carb, and...
-
Today I got the crank case together with new bearings. I’ve always used a sealant like dirko on the case gasket, but this will be an...
-
Cut some wood helping a forum member out. Good time great folks.
-
I’ve been burning trash since the beginning of October. There’s ton of old magazines and books but I never dug through anything other...
