Recent content by bennne

Poor consistency, might be ok in soft wood but not in Australian hardwoods. Many have been bitten once but not again. I have some trial loops and it’s rubbish, standard Chinese chain.

Listed in Aus as while stocks last. This may a region only thing though. They don’t offer the bang for buck the 261 does but I’d take on any day over a 261

Mtronic has a memory and uses the same setting as when you last used it so if it had been some to just do a recalibration. This system is not as complicated as people think

Yep I've got a loop of fc 3/8lp on the go ATM and don't rate it at all. Still slow after sharpening a couple times and lowering the rakers a bit. It also stretches, I recon I'll be out of adjustment by the time I'm to half a tooth

And our saws have all just dropped significantly in price. 661 1489usd rrp less haggling

By euro coil do you mean a non mtronic coil or a differently programmed mtronic one?

that's my old girl. It saw a lot of hard work before I got it and not well looked after. Pulled it down and stuck a set of rings in it replaced the filters, plug, blades and axle bushes and happy days

We're a masport dealer here and have never had an issue with them. I have an old s21 utility with a side valve Briggs on it and it goes great guns. Stihl used to get the push mowers and badge them as the Viking brand over here

I break and reuse them personally all the time but I do have a breaker and spinner so it makes the most of the available material

Those hose kits are a pain in the backside. I use the genuine stihl fuel line of the same size 2.7x5.4 I believe

20.70 is straight of the price file and I will discount for multiples, rim prices are more then they should be I agree, $10-12aud for 1 and go from there I would see as fair, buy bulk and get cheaper. I have approached jakmax/pmd about 3/8 picco rims as stihl are the only ones who sell them. I...

$20.70rrp but any who continue

I'm fairly sure the the Ktm 4 stroke RFS motor 00-07 is a Polaris or the other way around. Bloody tough motor and sought after for side car builds

As mdavlee mentioned above the extra links come about because the bar slot in a stihl bar is shorter then the d009 mount meaning the bar can not slide toward the sprocket more as the husky studs are further apart. I have an adaptor on my 7900 which I use a tsumura 25 .404 bar on which list 78 DL...