Basher's latest activity
-
I talked to Pete many, many times and he was a genuine original good old boy and fine human being. -
Pete was never one sided and always offered open minded advice on parts or techniques. Very sorry to hear of his passing. RIP you fine...
-
Just an update. I sent the saw out to Kevin and got it back in about a week. Great communication through the process, including pics...
-
The spring is to prevent the tube kinking, the vent on the 025 is shorter and lacking the arched support. I used ECHO Black fuel line...
-
In my case, I was disassembling my handle/ air box/ throttle linkage to remove the carb, when the saw fell off my dirtbike seat I had...
-
A simple tank vent from Echo can be utilized successfully in leu of the grub screws with the addition of just a tad bit longer fuel line...
-
I’d have an adjustable H jet installed rather than being limited to a fixed hole
-
The Terry plant was in Pointe Claire as is says on the label which is a suburb of Montreal. It was owned by Textron. Yours was made in...
-
Basher reacted to Vintage Engine Repairs's post in the thread Fix Your Inaccurate Compression Tester with
Like.
Did so for a mates tester and thought I’d share it here to document the process if anyone wants to know how: -
I picked this up at an estate sale for $25 cad , it was used as an ice saw . I pretty much just grabbed it for the bar
-
Sometimes you just get the wrong part which usually is not intensional .Which if you have the actual part number rather than just the...
-
I guy I know in Adamsville Pa. had an Aldens labeled 361 listed on Marketplace a few months back.
-
Scared of heat. Scared of nylon. Who hurt you? LOL
-
Make sure you’re applying pressure to the outer race if you press them. Applying force to the inner race can cause premature failure.
-
While it does not hurt to freeze the bearings, they do not shrink enough themselves, you will still need to heat the cases.