Recent content by Armbru84

All good man.

I am sure we could arrange something :borra2:

Back up. 900 and the ride.

Buy a green one from Huskihl or go to the unlimited.

Stihl MS661

SPF

XS ported 394 for long bar. I have only ran the saw a few tanks to do some long bar work…motor pulls and pulls like you would expect out of a Kevin saw. If I recall correctly had some new parts installed during the build but I need to confirm with Kevin. $875 and the ride PHO.

I would guess mine was the 3rd but who knows.

Hoping to be there Friday afternoon through Saturday. Try and bring a fun saw or 2. If we get bored Kev I could use some more poplar wood for chopping :beer-toast1:

Have a flywheel, coil, and carb that all come off a running saw together. This is what was on the 661 stroker originally before we swapped to non mtronic. I don’t have much to go on price wise…only eBay. 150 plus the ride for everything seems a decent clip under those prices. If I am off base...

Small world…been there a few times. I wouldn’t know until I boxed it. Shoot me a pm with your address and we can figure something out. We can cap it at something if you want. On the chains I have a ton of 404 so I can make almost anything. The ones I have now are full chisel and 1 is square. I...

It is .404 .063 with 111 Drivers. They do make a few different adapters which is what we were talking about above. Cannon has a few available and there may be others. http://www.cannonbar.com/wp-content/uploads/2019/06/8.-Adaptor-Plates.pdf...

Actually found another chain so it will have 2 chains with it.

Eh I didn’t have the best of luck with those springs either but in the end they did work. I ran it on my 084 I had awhile back so I didn’t really have to use it on my 3120. Those springs but a pc that’s the same width the whole diameter would work well.

Stihl big mount cannon superbar. Comes with the chain shown. Bar doesn’t have a ton of time on it. .404 .063 $225 and the ride. PayPal