Recent content by 94BULLITT

Thanks! Sent from my SM-G965U using Tapatalk

I subscribed to your channel too. You have some videos that look interesting. Sent from my SM-G965U using Tapatalk

I think it is $4 at the dealer but I can't drive to the dealer for $3 plus it would take a week to get it. Sent from my SM-G965U using Tapatalk

I can see where it is supposed to be. Sent from my SM-G965U using Tapatalk

I ordered this. https://www.ebay.com/itm/274636140748 Sent from my SM-G965U using Tapatalk

They could have done something better. At least they didn't put a stack of washers in there;)

It is not going back together til I have an oring for it. That is a poor design.

. Sent from my SM-G965U using Tapatalk

I said seal and meant oring.

I cut more than most, but I have a bunch of saws so the run time is shared between several saws. I do seem to run 4 or 5 saws for the part. The 660 kit is really good all though the crank failed in mine after 3 tanks. Everything on that kit fits and works nicely. My chain adjuster is a hair...

No, the seal is missing. I can see the gap between the crank and the bearing.

I'll pull the clutch tomorrow and see if it is there.If not I'll get one. Right now the saw is 99% farmertec, expect Stihl bolt and nut that was not included. I was going to run it a little and see what needed upgraded and get it all at once. I built 2 of these farmetec saws last week. This...

My seals were already installed. Sent from my SM-G965U using Tapatalk

I looked at the ipl when I was putting it together. The IPL showed the bushing, clutch, clutch drum etc. It didn't show the o ring. The o ring is shown with the crank, crank bearings, seals and the bushing is also shown again. The husqvarna ipl is a little weird. Was the o ring already on you...

Thanks, is that the bolt without threads on the end? Sent from my SM-G965U using Tapatalk