59billy's latest activity
-
59billy reacted to Kiwioilboiler's post in the thread Not so pros 4 new and without politics or drama with
Like.
Morena E Hoas. -
Got a new meteor 47mm cylinder if you want it, just send me your shipping address 👍
-
I was going to say the same thing, when I have seen only wear on the exhaust side, it is from firing the saw up cold and getting on it...
-
For quite some time the true 359 top end was no longer offered for sale, hence when you ordered a top end from Husqvarna, you received a...
-
In my experience, this is not how straight gassed usually presents. There is usually light transfer all the way around. A pressure+vac...
-
It’s got stuffers, I have a lot to learn admittedly but I hadn’t seen many posts where folks had a 359 topend on a 357 which is what...
-
Replacing the tank on an Echo 620. I wish all saws were this easy to work on. Pardon the messy bench. 3 min later Half an hour...
-
359 +359 718 Yup, mucho power!!!!
-
What's the indicator you use for that called?
-
I’d be curious to see this vid and the setup. While you’re 100% correct in dialing in the bore to be straight. Did they hit the base, or...
-
59billy replied to the thread Cheap scored 357XP.I've heard that a 359 top end on a 359 bottom end works pretty good, too.
-
Yes, just happened to have. I probably still prefer it the other way around, but it ain't terrible bad by any means.
-
What's the bottom end? Stuffers or no? Do you know why it's scored? Bad gas? Air leak? Will you be splitting the case? All, some...
-
Appreciate that. Given what I paid I’m just looking for a decent runner, nothing wild but I would like to try a little diy porting...
-
You could do either, if it cleans up and a new Meteor or Duke's piston is about as cheap as you can get. I put a Meteor 357 top on a 359...