59billy's latest activity
-
59billy replied to the thread What's on your bench?.Excellent! I've got a 345, a Chinese 350 riser, and a 353 top end that id like to stick together in my abundant free time. Did you do... -
I happened to compare a 350 to a 353-cylinder one time and what I noticed most was the upper transfers were much smaller in the 350...
-
That is the approach I’m going to take. No machine work on this one, but I’m doing to work the transfers a bit and widen the exhaust...
-
-
is it the super Bob?
-
I can take a pic of that. I noticed it helped when doing 350/346 builds. Not sure if it is really needed with the 350 cylinder.
-
Much tighter and you may run into thermal expansion problems.
-
Had it done for the same reasons as you in 2018. Was done under local anesthesia. Interesting what the OR crew talk about while...
-
59billy replied to the thread What's on your bench?.Did you by any chance, take pics of what you did on the transfer dividers? I've got a couple 353 cylinders id like to experiment with.
-
Husky 350 rebuild. Tore it all the way down to re-seal the bottom end. The cylinder riser was warped…I don’t think I have ever found...
-
Disconnect the kill switch wire at the coil to eliminate a bad wire/switch. If it sat forever fuel can varnish the inside of the tank...
-
I’ll try that. Today I re-tested p&c while cycling the piston and spraying soapy water all over… nada leaks. I moved on to assembling an...
-
I pulled the muffler on the 034,, still has machine marks on the slug. I massaged the muller a little. fuel line on order.
-
Well, p&v passed, carb passed...hmm... No air leaks Has to be some sort of fuel delivery issue. Vapor lock? I filled the tank about half...
-
The OEM 45mm cylinder is in good shape, and I have a meteor 353 piston, so I’m going to use that combo.
