59billy's latest activity
-
A simple way to think about it is the muffler outlet restricts flow. If you open it larger than another restriction in the saw, you’ve... -
Price reduced to $475 shipped lower 48
-
We might have to take this to a different thread because it’s a legitimate debate: Is back pressure valuable, or is it only helpful if...
-
And, what are the differences between ported and non ported saws when it comes to muf mods?
-
The bark box style covers have a pretty good deflector setup even though they are a front port. In general, they are just too damn loud...
-
Getting the hang of this. I think.
-
I will respectfully disagree. I've discussed this with porters who are far more knowledgeable than I am. A hole in the front of the...
-
I agree. I like ported saws not so much for the speed anymore but so I can cut with a longer bar on a smaller lighter saw.
-
Hard to switch sides when you're sitting on one of them, and the other is 15 feet off of the ground. I didn't need all 43", but I did...
-
59billy reacted to Kiwioilboiler's post in the thread Not so pros 4 new and without politics or drama with
Like.
Morena E Hoas. -
I'd like something that would lock down at least 10 teeth at a time to file per side of chain. Probably have to be about 24" long
-
So if you remove the knob completely you’ll see you can swap hole positions. I have never had the need but anyway just a review after...
-
I think someone asked if those knobs could end up being in the way. So mine has sat in the back of the truck and honestly treated...
-
At some point they merely get LOUDER. My SLR muffler PS-7310 was a pig stock, tuned to shy of 12.8k rpm! I disliked running her, I got...
-
I don’t have particular 661 knowledge here, but generally speaking it matters less how you open up the can, it matters how much. If a...