59billy's latest activity
-
260 not much difference over the 026 some are basically identical and others have 44.7 mm bore vs 44 after the epa regulations change... -
Flocked or winter mesh? If they’re pulling hard and choke spring is weak they will suck choke shut.
-
That's quite the elaborate design. Could the cranks get in the way?
-
I tried one of those at a GTG and it was quite nice, I do not recall the price however.
-
Homelite410 member on here makes a nice vise. I had this one powder coated
-
Yes and more is better if one has the space the money and need. One set up for 3/8 left cutter one for 3/8 right cutter, third set up...
-
Start off by using the same bar gauge. I can also put a stick 1x1 1x2 between the bottom of the bar and chain to tighten it up if needed.
-
Good point. You're talking about a different saw. In any case, what power gains do you expect to get with those minor modifications...
-
59billy reacted to GCJenks204's post in the thread Not so pros 4 new and without politics or drama with
Like.
Today we remember those who served and those who gave it all when they did Lest we forget. -
If the chain is not mounted on a saw/bar, nothing beats this. I am considering to buy a second one, but then again I reduced wood...
-
I’d like to try to modify an 036 to run a max flow filter. I think I would have to add longer carb studs to the carb box, modify an 044...
-
Piston diameter is the one thing I notice; 5 series compared to three series pistons of the same cc output are smaller, therefor easier...
-
Am I ever gonna get any royalties for starting the 543 love ? I tried to tell people they were good little units after being ported. Too...
-
Glitch? :p
-
hmmmm