59billy's latest activity
-
Good grief, I should be smart enough to figure that out myself! Thanks! -
It's not mtronic. I know that leaner is faster to a point and I'm going to have to richen it back out.
-
Tune for the highest RPM in the cut and then back the H jet out just a little bit.
-
Tune your saw under load in a good size log. Be sure it’s good and warmed up to operating temp. Get into a cut and lift the bar to take...
-
Don’t know where they are getting them. I would call them and find out. They may be getting them from other than Chicom.
-
Opening up a muffler will let the saw breathe and wot rpm’s will go up. All you have to do is open the H screw to drop things back to...
-
Anybody have input on the unlimited coils from Wolf Creek Saw? Good? Chinese junk? I know when I asked Randy about them he was pretty...
-
So here's my issue ive got a stock 362 I'd like to muffler mod. But how do you tune it then? Right now I'm just tuning by tach. I wish I...
-
59billy reacted to ammoaddict's post in the thread Not so pros 4 new and without politics or drama with
Like.
I bought a S&W Victory 22 years ago. I like it pretty well. It sort of resembles the old Ruger mark 2 -
59billy reacted to GCJenks204's post in the thread Not so pros 4 new and without politics or drama with Like.
Good Morning All!!
-
59billy reacted to Czed's post in the thread Not so pros 4 new and without politics or drama with Like.
Get one of these for your birthday Tor...
-
59billy reacted to Tor R's post in the thread Not so pros 4 new and without politics or drama with Like.
Good morning guys
-
59billy reacted to ammoaddict's post in the thread Not so pros 4 new and without politics or drama with Like.
Good morning. I think the rain just stopped
-
That test looks fishy. I’ve seen buildup in engines like that only once or twice, and that was on high hour trimmers getting run without...
-
An example of 1 is statistically meaningless. The most important alide is the one showing the valves. Notice that all the air cooled...