59billy's latest activity
-
Has the head ever been swapped out or removed and replace at any point? Too much sealer can plug the passage internall....or the wrong... -
If it were me, I'd tear it apart and use a Stihl clamp on it. Best of both worlds, and you'd probably run it more :cool:. Imo, the...
-
ultimately, who cares about the resale value...unless you plan on reselling it. if you spend $500 on a saw, any saw, and spend $300...
-
It's really not that bad Jeff and well worth doing, they are good little saws. It is also an excuse to get a 350 bearing cap and...
-
After the 660 build off saw failure, I had enough. Pulled threads can only be laughed off a certain number of times and it's not funny...
-
Old ones are not always suitable for use
-
59billy reacted to Kiwioilboiler's post in the thread Not so pros 4 new and without politics with
Like.
Morena E Hoas. -
59billy replied to the thread Aftermarket Rancher clutch covers.It seems it would make bar/chain changes less of a PITA with the outboard clutch.
-
Yes remove the tensioner on the saw and use the one in the new clutch cover
-
59billy replied to the thread HELP! 345 to 346 swap.Sometimes persistence is the secret ingredient. I need more of it.
-
Did you remove the stock tensioner on the saw? This would be nice for the 359 as well…
-
I sold my mmws 461R a couple years ago and immediately regretted it. Very nice saw
-
But imagine all that awesomeness when you're done. And for less than the one you have.
-
59billy reacted to damifino's post in the thread Echo chainsaws-How are the different grades identified? with Like.
CS4910 (50cc) is magnesium case with plastic side covers and is still available at Home Depot $379. Basically a CS501P but with plastic...
-
Which is totally normal around here.