300whisper's latest activity
-
No need to tear it all the way down for that area, it's far away from any gaskets and seals that could be damaged from heat. Leave the... -
I didn't find it too difficult to weld. I did heat the area pretty good a few times to sweat the oil & junk out of the crack. I did a...
-
300whisper reacted to Firewood Hoarder's post in the thread 359 case repair advice needed with
Like.
I've welded up similar oil-soaked stuff, and the biggest thing as others have said is cleaning and surface preparation. Light... -
300whisper replied to the thread 359 case repair advice needed.Thank you Sir, that is very helpful.
-
I've used ERAZ92A filler on a couple saw cases, but I'm not an expert. I set my tig welder to 150 but then used the pedal to control...
-
I haven't done mag welding personally. Its described as like welding aluminum but trickier. I know it is best to clean away the paint...
-
300whisper replied to the thread 359 case repair advice needed.I prepared cases in blasting cabinet with aluminum silicate, then put them in ultrasonic cleaner for half an hour, dishwashing liquid...
-
300whisper replied to the thread 359 case repair advice needed.Similar problem here. Bought pile of parts and there was 357XPG carcass with both case halves cracked. Flywheel side is easy one, but...
-
-
Good thing I stocked up........
-
300whisper reacted to Sawponder's post in the thread SELLING *reduced*Several new husqvarna/stihl oem cylinder kits and crankcases with Like.
3 - Husqvarna 372xpxt topend kits 150 plus shipping Sold 1 - Stihl 024 super or 026 (will not fit 024 because the stroke is longer *I...
-
300whisper reacted to Stump Shot's post in the thread Relevancy of Husqvarna 570 and 575xp loggers junk saws with Like.
One more thing to note, the case alignment pins are loose in the 575xp side case and not snug in the replacement 570 case half. Allowing...
-
300whisper reacted to Stump Shot's post in the thread Relevancy of Husqvarna 570 and 575xp loggers junk saws with Like.
There you have it folks, all ready to accept the "updated" 576xp top end. I think now you can see why it's not just a plug and play...
-
300whisper reacted to Stump Shot's post in the thread Relevancy of Husqvarna 570 and 575xp loggers junk saws with Like.
Used porting tools to get the finished shape.
-
300whisper reacted to Stump Shot's post in the thread Relevancy of Husqvarna 570 and 575xp loggers junk saws with Like.
A sharp flat chisel took care of any flash. Another go with the marker for final finish.
-
300whisper reacted to Stump Shot's post in the thread Relevancy of Husqvarna 570 and 575xp loggers junk saws with Like.
Epoxy is going to replace the voids.
