SOLD Target chop saw (Pioneer P-60)

[Guido Salvage]

This Target chop saw has been sitting in my garage for a couple of years, it is time for it to move on. I have a couple of Homelite XL-98's so I doubt I will never have a need for it.

This is a Pioneer based saw, I am guessing a P-51 as I did not pull the muffler to measure the bore. Compression measured 155 on my Snap-On tester after 6 pulls. The saw is missing the stack filter and cover but the felt filter is present and clean.

What you see is what you get, asking $175.00 plus the ride to your door from 40502.

 

[Guido Salvage]

Update on the saw, pulled the clutch cover and discovered it is a 1980 P-60, a 99 cc saw. I took a peek at the P&C, the piston looks nice but there are 2 streaks on the far side of the cylinder. I can't get my finger in to determine if it is a gouge.

I put a little mix in the carb and it fired off, I immediately shut it off as I didn't want to run it and potentially damage the cylinder.

 

[Guido Salvage]

Price drop to $150.

 

[Guido Salvage]

This is still under my bench, any interest?

 

[Guido Salvage]

Sold pending funds, this may be a new trenching saw...

 

[Guido Salvage]

Sold!